Technical Info On Robosapien

Robosapien Technical InfoFluid motions and gestures:Fast dynamic 2-speed walking and turningFull-function arms with two types of grippers67 pre-programmed functions: pick-up, throw, kick, dance, kung-fu, fart, belch, rap and more; 3 demonstration modes.Fully programmable on remote control: Up to 84 program steps with 4 program modes for advanced operations; programmable “reflexes” to sound and touch stimuli.Fluent international “caveman” speech.Extended battery life.About Mark Tilden:Mark, the designer of Robosapien, is a robotics physicist who has worked for NASA, DARPA and JPL through Los Alamos National Laboratory. He developed the basics for biomorphic robotics in 1988; Robosapien is the first commercially available robot based upon this principle.Where is Robosapien’s power switch?- It’s located just below his right shoulderblade. Press in to power him on; if he has previously shut down automatically, you will need to press the button twice (out and back in). Robosapien will respond with his “Wake Up” routine.Why does Robosapien seem to operate in the opposite direction from the controller?- The left side of the controller always operates Robosapien’s right side; the right side of the controller always operates his left side. So, if you are standing in front of him, the controller buttons line up directly to the side which will move; if you are standing behind him, the controller buttons line up vertically to the side which will move.- Try working the remote upside down if that is more comfortable for you.Why won't Robosapien respond to the controller?Robosapien is "blinded" by sunlight or electronically dimmed lighting.Try lowering his visor, or remove him from the interference source.- Robosapien could be in LISTEN, REACTION, or SLEEP mode. Press RESET to get his attention.- Robosapien can't "see" the remote signals. Always point the remote control at his head.- Robosapien is too far away. Move closer to him.What if Robosapien is not walking well?- Try pressing STEP again for the sure-footed "slow walk" mode, or, if stopped, press STEP-STEP.- Only operate Robosapien on a hard floor or low-pile carpet. He has trouble walking on deep shag, grass, sand, or cloth.- Make sure there are no obstructions, wires, or string limiting Robosapien’s motion.- Maybe his batteries need changing.Why can't Robosapien pick up low objects from the floor?-Robosapien will damage his fingers if he bends down too low. He can only pick up items that are greater than approximately 2” high, such as paper cups, socks in a ball, bent business cards, crumpled paper, etc.- If you put Robosapien in a dimly lit environment, his palm lights will show you where his two pick-up “sweet spots” are located. When you do a pick-up command, he can very reliably pick things up which are placed in these spots located next to his ankles.Why does Robosapien have two types of hands?- His right hand is for round or bulky things like dolls, cardboard tubes, etc.His left hand is for thin things like pencils, napkins, dollar bills, business cards, and paper. Use his hands to lift things, hold and carry them, and even put them on steps or in laundry bags, for example.What if Robosapien doesn’t walk while he is carrying something?- If Robosapien is holding something that will flop against his sensor (like along ruler), the sensor may false trigger and he may stop walking. If that is the case, press SELECT-FORWARD or SELECT-SELECT-FORWARD (bulldozer action) and Robosapien will walk.Robosapien stops whenever he's stuck against a wall. How do I get him away from it?- Press SELECT-FORWARD or SELECT-BACKWARD to get him away from objects that keep tripping his sensors. You can also press SELECT-SELECT-BULLDOZER to make Robosapien kick his way through things in front of him.Why can't Robosapien fast walk with his arms all the way up?- On some surfaces your robot cannot walk well while his hands are all the way up or while he's carrying something heavy. However, just press STEP again (or, if stopped, press STEP-STEP) and he'll walk fine.How do I make Robosapien walk straight when his arms are not balanced?- By pressing the STEP button again, or, if stopped, by pressing STEP-STEP. This puts him into the much more stable "slow-walk" mode. Slow-walk allows Robosapien to push, pull, or kick his way out of many situations.. If he continues to stop, use the "SELECT-SELECT-BULLDOZER" mode; he will push through any obstacle he can.Robosapien’s head has turned to the right; I have not been able to re-center it. Do you have any suggestions for repair?- Lower his arms and twist his head all the way to the left, until you hear a "click".How can I make Robosapien quieter?- Cover the speaker grill on his back with tape.Is there a way to make Robosapien remember his programming?- No, but in SLEEP mode he will remember his programming for up to 2 hours before he completely turns himself off and forgets everything. In SLEEP mode, he will ignore all touch sensors until you wake him up with your remote control.During wake-up, I hear Robosapien making strange humming sounds. Is this something to worry about?- No, it is part of the normal wake-up protocol.Why does Robosapien have lights in his palms?- So he can look cool patrolling around at night, of course. Several command functions cause his palm lights to come on.Can my Robosapien do housework?- Sort of. He can push lightweight boxes, kick toys against a wall, retrieve hankerchiefs and pile them on steps, pick up light laundry and throw it in bags, among other housekeeping chores.Why didn't Robosapien start after I put in fresh batteries?- Make sure he is not lying down when you power him up or he'll think he's stuck and won't power on.- Always power on Robosapien standing upright in a clear, open space.- Make certain that the battery-pull straps inside his feet are not caught between the batteries and contacts.- Check that all batteries are placed in the correct direction in the battery housings.What happens if I forget to turn off Robosapien?- If you ignore him, Robosapien will stop and go to sleep after 5 minutes. If he gets no remote signal for 2 hours, he will shut off completely (even if the power button is still in the “on” position).What are the 67 Robosapien functions?1) Right Arm Up2) Right Arm Down3) Right Arm In( LFT) Left Spin/Walk Button4) Right Arm Out (FWD) Forward Walk/Slow5) Tilt Body Right(BK) Backward Walk/Slow6) Left Arm Up(RSD) Right Shoulder Down7) Left Arm Down(LSD) Left Shoulder Down8) Left Arm In (RSU) Right Shoulder Up9) Left Arm Out (LSU) Left Shoulder Up10) Tilt Body Right (RFO) Right Forearm Out11) Turn Right12) Walk Forward13) STOP Button14) Turn Left15) Walk Backward16) (R>) Right Sensor Program17) (S>) Sonic Program18) (L>) Left Sensor Program19) (R>) Right Sensor Program20) (P) Master Command Program21) (SELECT) Advance to GREEN Keys22) Right Hand Thump23) Left Hand Pickup24) Lean Backward25) Right Hand Throw26) Sleep27) Left Hand Thump28) Left Hand Pickup29) Lean Forward30) Left Hand Throw31) Listen32) Forward Step33) Right Turn Step34) Backward Step35) Right Sensor Program Execute36) Master Command Program Execute37) Wake Up38) Reset39) Left Turn Step40) (SELECT) Advance to ORANGE Keys41) Left Sensor Program Execute42) Sonic Sensor Program Execute43) Right Hand Sweep44) High 545) Right Hand Strike 146) Burp47) Right Hand Strike 248) Left Hand Sweep49) Talk Back50) Left Hand Strike 151) Whistle52) Left Hand Strike 253) Bulldozer54) Right Hand Strike 355) Oops!56) Demo157) All Demo58) Power Off59) Roar60) Left Hand Strike 361) (Select) Return to RED Command Functions62) Demo263) Dance Demo64) <, < Combination "Right Walk Turn"65) >, > Combination "Left Walk Turn"66) Forward, Forward Combination "Slow Walk Forward"67) Backward, Backward Combination "Slow Walk Backward"What are the 4 programming modes?1. Master Program (P) General control programs2. Right Sensor Program (R> ) Triggered by touch to finger, toe or heel sensoron right side3. Left Sensor Program (L> ) Triggered by touch to finger, toe or heel sensoron left side4. Sonic Sensor Program (S>) Triggered by a sharp sound or tap on his body.What is the function of the wires that stick out of Robosapien’s arms?- The wires carry power and sensor information to and from his hands.They also act as soft bumpers if Robosapien gets too close to a wall.