Duratrax Kwik-Pit Super Start DTX HPI .12-.18 DTXP6000

Duratrax Kwik-Pit Super Start DTX HPI .12-.18 DTXP6000

Put an end to recoil starter headaches and add one-hand starting ease by installing the Kwik-Pit Super Start System from DuraTrax on your model. This version will convert recoil or Roto Start equipped HPI .12-.18, DuraTrax Velocity .15-.18 and DuraTrax Torq .21, Picco .12-.18 and Dynamite .12-.18 size engines

Features

• Duratrax Kwik-Pit Super Start DTX HPI .12-.18 DTXP6000

• Easy one-hand starting means the end of blisters and broken recoil ropes

• Powerful twin 540 motors are powered by twin 6-cell sub-C stick battery packs (not included) Unit will not operate on only one pack

• Steel gear drive

• Dust and impact resistant composite plastic case

• Hinged access door provides for easy battery installation

• ON/OFF rocker switch with safety side guards

• Twin ball bearing-supported gear drive

• Two clips on the unit's bottom for storage of starting shaft

Specifications

• -Starting Unit

• Length: 10" (254mm)

• Width: 2.1" (53mm)

• Height: 4" (101mm)

• -Starting Shaf

• Length: 7.25" (185mm)

• Diameter: .21" (5.4mm)

 Contents

• One Kwik-Pit Super Start power unit

• One front and rear gear case - key number 20 (DTXP6055)

• One 32 tooth steel, adapter gear - key number 14

• One 11 tooth steel, small adapter gear - key number 12 (DTXP6045)

• Four 2.6x10mm hex head screws - key number 25 (DTXQ0283) (requires a 2mm allen wrench for installation - DTXR0252)

Requirements

• The stock engine back plate and one way bearing

• Two 6-cell sub-C batteries and charger - DTXP4600 or modeler's choice

• Installation following included instructions sheet

Comments

• This is not for use on the Savage vehicles.

• The only .21 size engine this starter will fit is the DuraTrax Torq .21.